final case classIn(rate: Rate, bus: GE, numChannels: Int = 1) extends MultiOut with IsIndividual with Product with Serializable
A UGen that reads a signal from a bus. Whether an audio- or control-bus is used
depends on the rate of the UGen.
In.ar and In.kr behave differently with respect to signals left on the bus
in the previous calculation cycle (control block): In.ar can access audio
signals that were generated in the current calculation cycle by synths appearing
earlier in the node tree. It does not read signals produced by nodes in the
previous calculation cycle (i.e. synths appearing later in the node tree), the
input would instead be zero. To allow such "feedback", InFeedback can be used.
In contrast, In.kr does not distinguish between "new" and "old" data: It will
always read the most recent value found on the bus, whether it was generated
earlier in this calculation cycle, left over from the last one, or set before by
the client.
Note: The server uses the first NumOutputBuses channels to write to the
sound card, followed by another NumInputBuses to read from the sound card. For
convenience, the pseudo-UGens PhysicalOut and PhysicalIn can be used.
bus
index of the bus to read from. When numChannels is
greater than one, the other channels or read from the
adjacent indices.
A UGen that reads a signal from a bus. Whether an audio- or control-bus is used depends on the rate of the UGen.
In.arandIn.krbehave differently with respect to signals left on the bus in the previous calculation cycle (control block):In.arcan access audio signals that were generated in the current calculation cycle by synths appearing earlier in the node tree. It does not read signals produced by nodes in the previous calculation cycle (i.e. synths appearing later in the node tree), the input would instead be zero. To allow such "feedback",InFeedbackcan be used.In contrast,
In.krdoes not distinguish between "new" and "old" data: It will always read the most recent value found on the bus, whether it was generated earlier in this calculation cycle, left over from the last one, or set before by the client.Note: The server uses the first
NumOutputBuseschannels to write to the sound card, followed by anotherNumInputBusesto read from the sound card. For convenience, the pseudo-UGensPhysicalOutandPhysicalIncan be used.index of the bus to read from. When
numChannelsis greater than one, the other channels or read from the adjacent indices.number of channels to read
Bus
LocalIn
InFeedback
PhysicalIn
Out