the first FFT'ed buffer (this gets replaced by the output signal)
the second FFT'ed buffer
the number of periods in the rectangle wave, where zero would mean the first input signal is fully passed through, one means that there is exactly one period of the wave across the spectrum, hence one pass-band (first signal passed through) and one stop-band (second signal passed through).
the phase offset of the rectangle wave, where 1.0 is one full period. This is like the offset into the wavetable holding the rectangle, so a value of 0.25 means we start 25% into the basic waveform, and after 0.75 periods the next full period (high slope) begins.
the pulse width between 0.0 (infinitely small high slope, so all bins are copied from the second input) to 0.5 (half period is high slope -- copied from first input --, half period is low slope -- copied from second input) to 1.0 (maximally wide high slope, so all bins passed from the first input).
the first FFT'ed buffer (this gets replaced by the output signal)
the second FFT'ed buffer
the number of periods in the rectangle wave, where zero would mean the first input signal is fully passed through, one means that there is exactly one period of the wave across the spectrum, hence one pass-band (first signal passed through) and one stop-band (second signal passed through).
the phase offset of the rectangle wave, where 1.
the phase offset of the rectangle wave, where 1.0 is one full period. This is like the offset into the wavetable holding the rectangle, so a value of 0.25 means we start 25% into the basic waveform, and after 0.75 periods the next full period (high slope) begins.
the pulse width between 0.
the pulse width between 0.0 (infinitely small high slope, so all bins are copied from the second input) to 0.5 (half period is high slope -- copied from first input --, half period is low slope -- copied from second input) to 1.0 (maximally wide high slope, so all bins passed from the first input).
A phase vocoder UGen that switches between two input spectra according to a rectangle wave. This is basically identical to
PV_RectComb, however during the low slopes of the rectangle wave, instead of clearing out the bins, it copies over the corresponding bins of the second fft input buffer.the first FFT'ed buffer (this gets replaced by the output signal)
the second FFT'ed buffer
the number of periods in the rectangle wave, where zero would mean the first input signal is fully passed through, one means that there is exactly one period of the wave across the spectrum, hence one pass-band (first signal passed through) and one stop-band (second signal passed through).
the phase offset of the rectangle wave, where 1.0 is one full period. This is like the offset into the wavetable holding the rectangle, so a value of 0.25 means we start 25% into the basic waveform, and after 0.75 periods the next full period (high slope) begins.
the pulse width between 0.0 (infinitely small high slope, so all bins are copied from the second input) to 0.5 (half period is high slope -- copied from first input --, half period is low slope -- copied from second input) to 1.0 (maximally wide high slope, so all bins passed from the first input).
PV_RectComb